Dave,
The Nugget Finder Evolution coils use a vinyl coil tape, it is available at Goldsearch Dunolly. It goes on easy with no kinks. I hope this helps.
Regards
Jeff
I had worn out my commercial pick, but the handle was still in good condition. So I cut back the worn out pick end, cut a new blade from a plough disk, welded a small cold chisel to the point of the blade and then drilled and bolted this onto the handle. I can now replace the blade when it wears...
On my 4500 I normally use a Nugget Finder 14 x 9 mono, I also have the Minelab 11 inch DD, a Coiltek 10 x 5 mono Joey Coil and a P &M Coils 18 x 6 Nuggeteer mono patchfinder.
Regards
Turps123
MJB, the shaft opposite rays is the old Reform Mine, I was told this closed down because they could not stop water seepage. The pumps that they had could not handle the amount of water and the mine flooded.
Brutus and me, the Waanyarra area is very good for the odd piece, a mate of mine last...
Hi MJB,
Yes there is colour in the Ovens river and the Barwidgee creek, but they are on the exempt rivers and streams list.
In the early days these waterways were subject to hydraulic mining and did major damage to the area.
Yes been up the Buckland a few times ( without luck), most of the...
After a long warm summer here at the base of mountains, I finally take off tomorrow for the GT for a 6 week period ( lucky me :D ). This will be my third trip to the GT this year. The first two trips were a huge learning curve with lots of good advice from the campers around ( all prospectors)...