Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Whites
Whites TDI Pro, let the testing begin.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Rusty71" data-source="post: 105471" data-attributes="member: 3580"><p>Hi Wal</p><p></p><p>I am currently up in the Leonora area and found today being warm and not ideal detecting weather I couldn't get a good ground balance in all.I got good GB in low or in high but they were just enough different to make "all" noisy.</p><p></p><p>Would you be able to give a rough setting for PWR/GAIN, threshold etc that you usually set the detector at so I can see if I am somewhere close to where I need to be.</p><p></p><p>I was quite happy with the detector in low today and the area I am in has been detected a lot so I think I was ok but would like to try and keep it set in "all" if possible. </p><p></p><p>I also found when set with the threshold silent it would not pick up my .31g test piece so any suggestion will be apprietiated. </p><p></p><p>I am currently using a 14 x 9 nugget finder coil. </p><p></p><p>Thanks</p><p>Rusty</p></blockquote><p></p>
[QUOTE="Rusty71, post: 105471, member: 3580"] Hi Wal I am currently up in the Leonora area and found today being warm and not ideal detecting weather I couldn't get a good ground balance in all.I got good GB in low or in high but they were just enough different to make "all" noisy. Would you be able to give a rough setting for PWR/GAIN, threshold etc that you usually set the detector at so I can see if I am somewhere close to where I need to be. I was quite happy with the detector in low today and the area I am in has been detected a lot so I think I was ok but would like to try and keep it set in "all" if possible. I also found when set with the threshold silent it would not pick up my .31g test piece so any suggestion will be apprietiated. I am currently using a 14 x 9 nugget finder coil. Thanks Rusty [/QUOTE]
Verification
Post reply
Metal Detectors
Whites
Whites TDI Pro, let the testing begin.
Top