Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Minelab
Minelab X-terra 705 General Tips, Advice, Questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Smoky bandit" data-source="post: 321954" data-attributes="member: 7289"><p>Make sure you set your auto noise cancell first...Then auto ground balance....i keep my target id stablizer on all the time...the little + near the coin simble....coins should not change numbers to much unless its a sunbaker...which will give a double beep..or its more than 8 inchs...deep....or next to another target...The numbers are just a guide to what the machine thinks the target is so dont rely on it to much...Though when looking for coins i have found the target id to be very helpful.....if its a coin... say a $2coin ...for my machine it will always read a stable 32...and a $1coin will jump from 30 to 32 even to 34 at times but with constant sweeps it will usually settle on 30...also when you press pinpoint auto...(not pimpoint sizing)...if it is a coin (say a $2) The target id should stay at 32...if it drops by more 4 its more than likely not a coin...Hope this makes sence :Y:</p></blockquote><p></p>
[QUOTE="Smoky bandit, post: 321954, member: 7289"] Make sure you set your auto noise cancell first...Then auto ground balance....i keep my target id stablizer on all the time...the little + near the coin simble....coins should not change numbers to much unless its a sunbaker...which will give a double beep..or its more than 8 inchs...deep....or next to another target...The numbers are just a guide to what the machine thinks the target is so dont rely on it to much...Though when looking for coins i have found the target id to be very helpful.....if its a coin... say a $2coin ...for my machine it will always read a stable 32...and a $1coin will jump from 30 to 32 even to 34 at times but with constant sweeps it will usually settle on 30...also when you press pinpoint auto...(not pimpoint sizing)...if it is a coin (say a $2) The target id should stay at 32...if it drops by more 4 its more than likely not a coin...Hope this makes sence :Y: [/QUOTE]
Verification
Post reply
Metal Detectors
Minelab
Minelab X-terra 705 General Tips, Advice, Questions
Top