Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Minelab
Minelab GPX 4500 information and questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="PhaseTech" data-source="post: 323874" data-attributes="member: 3149"><p>The 11" Commander mono in Enhance is still very sensitive. Spend a bit of time getting your Rx Gain and Stabilizer set correctly. The best way to do this is to bury a small bit of lead and bury it to where you're just hearing a faint signal in the factory settings. Then slowly increase your Rx while sweeping on the surrounding ground and over the target. If you are getting excessive ground noise then lower the Rx. </p><p>Then when the Rx is set, adjust your Stabilizer. For maximum sensitivity you want the Stabilizer as high as possible but ignore the number and just set it where your machine sounds good to you. Try and avoid setting it below 6 as I feel that chokes the audio a bit too much.</p></blockquote><p></p>
[QUOTE="PhaseTech, post: 323874, member: 3149"] The 11" Commander mono in Enhance is still very sensitive. Spend a bit of time getting your Rx Gain and Stabilizer set correctly. The best way to do this is to bury a small bit of lead and bury it to where you're just hearing a faint signal in the factory settings. Then slowly increase your Rx while sweeping on the surrounding ground and over the target. If you are getting excessive ground noise then lower the Rx. Then when the Rx is set, adjust your Stabilizer. For maximum sensitivity you want the Stabilizer as high as possible but ignore the number and just set it where your machine sounds good to you. Try and avoid setting it below 6 as I feel that chokes the audio a bit too much. [/QUOTE]
Verification
Post reply
Metal Detectors
Minelab
Minelab GPX 4500 information and questions
Top