Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Prospecting Equipment
Gold Crevicing Tools information and questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="PeterHarden" data-source="post: 16117" data-attributes="member: 776"><p>I made a tool with a bit of metal tubing, prob 12mm, bent it at the end so about 3-4 cm at about 45 degree angle to the rest which is the handle about 40cm long. Bashed the end bit narrower, about 6mm, then took to it with a hack saw to put a point on it going back from the bottom lip. Works ok so far.</p><p></p><p>PS. would have been easier to put a pic up !</p></blockquote><p></p>
[QUOTE="PeterHarden, post: 16117, member: 776"] I made a tool with a bit of metal tubing, prob 12mm, bent it at the end so about 3-4 cm at about 45 degree angle to the rest which is the handle about 40cm long. Bashed the end bit narrower, about 6mm, then took to it with a hack saw to put a point on it going back from the bottom lip. Works ok so far. PS. would have been easier to put a pic up ! [/QUOTE]
Verification
Post reply
Gold Prospecting
Prospecting Equipment
Gold Crevicing Tools information and questions
Top