You are not logged in.

  • Register to access all forum features  

#1

Greybeard
Member
From: Toowoomba, QLD
Joined: 21 September 2016
Posts: 24
Member
13 November 2016 06:45 pm

Hi All
Just started a piece of Cristinite in an Emerald cut. But it didn't go well.
I have the angles, indexes etc but no instructions so did what I thought seemed logical. Pavillion end facets points just don't meet.
Can anyone point me to some good instructions on cutting rectangular stones please?

#2

Mr Magoo
Member
Joined: 04 May 2014
Posts: 126
Member
14 November 2016 09:23 pm

I would consider the Emerald cut to be one of the hardest cuts to do well. The bigger the stone, the harder it gets. Absolutely fantastic at showing up errors in you and your machine. Make sure cheaters are zero'd.

Anyway here is a link: http://www.polymetricinc.com/articles.htm that may or may not help.

#3

Mr Magoo
Member
Joined: 04 May 2014
Posts: 126
Member
14 November 2016 09:27 pm

Won't let me edit previous post but the article you want is half way down the page.

Contact Us - Privacy Policy - Terms Of Service

View Desktop Site

Top