Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Metal Detecting for Gold
White's MXT Pro / Vic Gold Trip
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Moneybox" data-source="post: 598583" data-attributes="member: 3960"><p>If anybody is concerned about the difficulty of learning the GPX4500 then I suggest you do like I did. I knew nothing about setting up the machine so I held down the on-button for a little longer, it gave me two options for a factory reset. I reset all. Next I pressed the Auto Tune button and waited the minute for it to scan for EMI. Next I did the ground balance that took about 15 seconds. Google told me I should run it in 'Enhance' in Western Australia so I flicked that switch.</p><p></p><p>From there I went detecting and found gold. I never changed coils or other settings until I felt I understood the detector enough to do so. Even then I did little more than adjust the sensitivity. There are a lot of setting options but there's no reason to tamper with them. Factory settings will find gold in most conditions.</p></blockquote><p></p>
[QUOTE="Moneybox, post: 598583, member: 3960"] If anybody is concerned about the difficulty of learning the GPX4500 then I suggest you do like I did. I knew nothing about setting up the machine so I held down the on-button for a little longer, it gave me two options for a factory reset. I reset all. Next I pressed the Auto Tune button and waited the minute for it to scan for EMI. Next I did the ground balance that took about 15 seconds. Google told me I should run it in 'Enhance' in Western Australia so I flicked that switch. From there I went detecting and found gold. I never changed coils or other settings until I felt I understood the detector enough to do so. Even then I did little more than adjust the sensitivity. There are a lot of setting options but there's no reason to tamper with them. Factory settings will find gold in most conditions. [/QUOTE]
Verification
Post reply
Gold Prospecting
Metal Detecting for Gold
White's MXT Pro / Vic Gold Trip
Top