Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
General
General Chat
Today I MADE
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="HeadsUp" data-source="post: 87874" data-attributes="member: 414"><p>material under 3 mm is usually done with TIG but MIG works too.</p><p></p><p>the trick with Ali mig is to clean it well , and use a hot and fast feed rate.</p><p></p><p>any oxide , dirt or grease on the surface just creates fumes , oxidation or smoke which inhibit fusion.</p><p></p><p>wire brush before welding is the go.</p></blockquote><p></p>
[QUOTE="HeadsUp, post: 87874, member: 414"] material under 3 mm is usually done with TIG but MIG works too. the trick with Ali mig is to clean it well , and use a hot and fast feed rate. any oxide , dirt or grease on the surface just creates fumes , oxidation or smoke which inhibit fusion. wire brush before welding is the go. [/QUOTE]
Verification
Post reply
General
General Chat
Today I MADE
Top