Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
QED
QED users - how are you faring?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Guest" data-source="post: 358199"><p>If you get noise when the control box is squeezed then your QED has a fault! Return it to be checked out under warranty and get the new firmware and the bias capacitor replaced before you give up. The original QED was not tested in WA but was tested over some similar ground at the Teetulpa GF in SA which is horrendous in places. As i have posted earlier a QED user in the NT can run his <u>updated</u> QED over NT <strong>laterites</strong> and very nasty <strong>dolerites.</strong></p><p>You have still not said what mode/vol/gain settings you were using on your QED. The ground <u>cannot wind up the QED</u> and the QED is being used on ground where the GB reading is over 150! There is ground that the QED cannot handle eg very reactive frequency dependent susceptible ground on the margins of salt lakes.</p></blockquote><p></p>
[QUOTE="Guest, post: 358199"] If you get noise when the control box is squeezed then your QED has a fault! Return it to be checked out under warranty and get the new firmware and the bias capacitor replaced before you give up. The original QED was not tested in WA but was tested over some similar ground at the Teetulpa GF in SA which is horrendous in places. As i have posted earlier a QED user in the NT can run his [u]updated[/u] QED over NT [b]laterites[/b] and very nasty [b]dolerites.[/b] You have still not said what mode/vol/gain settings you were using on your QED. The ground [u]cannot wind up the QED[/u] and the QED is being used on ground where the GB reading is over 150! There is ground that the QED cannot handle eg very reactive frequency dependent susceptible ground on the margins of salt lakes. [/QUOTE]
Verification
Post reply
Metal Detectors
QED
QED users - how are you faring?
Top