Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
QED
QED Use/Settings - Review of Each Detecting Trip
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Dave63" data-source="post: 522426" data-attributes="member: 16796"><p>G'Day All</p><p></p><p>I have made a rough and ready video which is on Youtube. </p><p></p><p>After I do my initial setup as talked about above I off camera apply all the advice I have received on this AEGPF and Detector Prospector</p><p></p><p>So the end setup was reached by</p><p></p><p>1. Factory Reset</p><p>2. MGB - Changed from default to 220 as a start point - Not balance yet though.</p><p>3. Mode - Set to 3</p><p>4. THS-B - Set to Null</p><p>5.THS-A - Set to highest I can get until I hear a soft tone</p><p>6. Gain - Set to 6</p><p>7. Adjust THS-B and THS-A to stop noise created by Gain at 6</p><p>8. Lower THS-B couple clicks below Null for enhance small target response.</p><p></p><p>I think this setup still requires some tuning. Time in the field swinging is required. I need to carry a test piece of lead to confirm my setup at each location.</p><p></p><p>Video </p><p></p><p><a href="https://youtu.be/dL2Z8-29G_k" target="_blank">https://youtu.be/dL2Z8-29G_k</a></p><p></p><p>Spielberg I am not</p></blockquote><p></p>
[QUOTE="Dave63, post: 522426, member: 16796"] G'Day All I have made a rough and ready video which is on Youtube. After I do my initial setup as talked about above I off camera apply all the advice I have received on this AEGPF and Detector Prospector So the end setup was reached by 1. Factory Reset 2. MGB - Changed from default to 220 as a start point - Not balance yet though. 3. Mode - Set to 3 4. THS-B - Set to Null 5.THS-A - Set to highest I can get until I hear a soft tone 6. Gain - Set to 6 7. Adjust THS-B and THS-A to stop noise created by Gain at 6 8. Lower THS-B couple clicks below Null for enhance small target response. I think this setup still requires some tuning. Time in the field swinging is required. I need to carry a test piece of lead to confirm my setup at each location. Video [url]https://youtu.be/dL2Z8-29G_k[/url] Spielberg I am not [/QUOTE]
Verification
Post reply
Metal Detectors
QED
QED Use/Settings - Review of Each Detecting Trip
Top