Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Alluvial Gold Prospecting
Newbie wanting to get his hands wet
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="B5MECH" data-source="post: 297395" data-attributes="member: 6829"><p>The runin time should be about 2hrs at 50% load after 2 hrs slowly increase load slowly over a few minutes then shut off and let cool for a little then drain for as long as possible that's for a gene not a pump so not sure about a load rating, I'd be doing it at home not when your out</p><p>Run in oil get's dirty quick</p><p>so a couple of hours and it's done</p><p>I'm guessing load on the pump would be flow of water + throttle % opening</p><p>Don't get to %100 percent load during run in about 70% max, you'll hear some people say 100% but don't listen to them they don't know <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite11" alt=":rolleyes:" title="Roll Eyes :rolleyes:" loading="lazy" data-shortname=":rolleyes:" /> </p><p>100% load and too long run in time on run in will wear and can even spin bottom end and main bearings <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile :)" loading="lazy" data-shortname=":)" /></p></blockquote><p></p>
[QUOTE="B5MECH, post: 297395, member: 6829"] The runin time should be about 2hrs at 50% load after 2 hrs slowly increase load slowly over a few minutes then shut off and let cool for a little then drain for as long as possible that's for a gene not a pump so not sure about a load rating, I'd be doing it at home not when your out Run in oil get's dirty quick so a couple of hours and it's done I'm guessing load on the pump would be flow of water + throttle % opening Don't get to %100 percent load during run in about 70% max, you'll hear some people say 100% but don't listen to them they don't know :rolleyes: 100% load and too long run in time on run in will wear and can even spin bottom end and main bearings :) [/QUOTE]
Verification
Post reply
Gold Prospecting
Alluvial Gold Prospecting
Newbie wanting to get his hands wet
Top