Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Minelab
Minelab SDC2300 information and questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Norvic" data-source="post: 303895" data-attributes="member: 4596"><p>Grab a roll of 0.8 or 1mm Poly carbonate sheet from Bunnings. Cut with a pair of tinsnips(Wiss snips)to say 5mm radius bigger then coil. Roughen up poly carb and adhere to coil with silastic. It will last for yonks is light tough and with the SDC you can cut it of size that protects the knuckle. Makes a brilliant coil cover for 19 Z coil. Just make sure you remove the protective plastic film on side you wish to glue.</p></blockquote><p></p>
[QUOTE="Norvic, post: 303895, member: 4596"] Grab a roll of 0.8 or 1mm Poly carbonate sheet from Bunnings. Cut with a pair of tinsnips(Wiss snips)to say 5mm radius bigger then coil. Roughen up poly carb and adhere to coil with silastic. It will last for yonks is light tough and with the SDC you can cut it of size that protects the knuckle. Makes a brilliant coil cover for 19 Z coil. Just make sure you remove the protective plastic film on side you wish to glue. [/QUOTE]
Verification
Post reply
Metal Detectors
Minelab
Minelab SDC2300 information and questions
Top