Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Detector Accessories
Minelab Pro sonic wireless system
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bob" data-source="post: 573427" data-attributes="member: 628"><p>Thanks for the replies. The low static response was just like someone wiggling a loose speaker wire. I didn't expect that there would be any static at all. I have the sender mounted on the outside of the cover on the left next to the handle. I had the receiver unit atttatched to the right strap of my back pack. I like the set up in the picture. I will see if I can set up something similar. Also I thought it may help to just have the threshold setting on the lowest as the receiver unit has a volume control and will amplify the detector signals. I haven't come across any mention of static problems with the units so it makes me think that there could be a problem with mine. The noise is really low level though and the EMI was really tough yesterday. It took lots of noise cancelling to find an operational level at sensitivity three which is what I usually run. It seemed like the low static was part of the EMI and the speaker on the pro sonic was just amplifying it. Anyway thanks for your input and I will see what transpires next week.</p><p></p><p>Cheers Bob.</p></blockquote><p></p>
[QUOTE="bob, post: 573427, member: 628"] Thanks for the replies. The low static response was just like someone wiggling a loose speaker wire. I didn't expect that there would be any static at all. I have the sender mounted on the outside of the cover on the left next to the handle. I had the receiver unit atttatched to the right strap of my back pack. I like the set up in the picture. I will see if I can set up something similar. Also I thought it may help to just have the threshold setting on the lowest as the receiver unit has a volume control and will amplify the detector signals. I haven't come across any mention of static problems with the units so it makes me think that there could be a problem with mine. The noise is really low level though and the EMI was really tough yesterday. It took lots of noise cancelling to find an operational level at sensitivity three which is what I usually run. It seemed like the low static was part of the EMI and the speaker on the pro sonic was just amplifying it. Anyway thanks for your input and I will see what transpires next week. Cheers Bob. [/QUOTE]
Verification
Post reply
Metal Detectors
Detector Accessories
Minelab Pro sonic wireless system
Top