Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Minelab
Minelab GPX4500 tips, settings, questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Baldy" data-source="post: 181488" data-attributes="member: 5602"><p>Took the new 4500 for a bit of a test today..put a .06 gr nut down 6 inches in a hole and tried to get a sig..was using the coiltek Como 14 inch..was using Nugget Magnet,s settings..front gen,enhance,fixed...rear,vol limit17 ,gen,main tune. 120 set manually, v/slow,r X11, normal, tone,50 ,stab 9, signal 17, target vol 17 response norm.....could hear a positive sig..but was at its limit..tested an older 4500, same coil and much same settings and audio signal was the same..tried a 5000 same coil and settings same also..switch 5000 to fine gold and ...could not hear target...interesting...I switched stabiliser on new 4500 from 9 to 1 and was more stable and could even hear target better..tried it on the 5000 and lost the target signal...?...put a 8x6 Satie on thinking it would scream and I could,nt hear it ...had to pull the target up 3 inches before could hear it..? Hope you can understand all that..put the 11inch mono on and couldn't hear it... Coiltek rules..</p></blockquote><p></p>
[QUOTE="Baldy, post: 181488, member: 5602"] Took the new 4500 for a bit of a test today..put a .06 gr nut down 6 inches in a hole and tried to get a sig..was using the coiltek Como 14 inch..was using Nugget Magnet,s settings..front gen,enhance,fixed...rear,vol limit17 ,gen,main tune. 120 set manually, v/slow,r X11, normal, tone,50 ,stab 9, signal 17, target vol 17 response norm.....could hear a positive sig..but was at its limit..tested an older 4500, same coil and much same settings and audio signal was the same..tried a 5000 same coil and settings same also..switch 5000 to fine gold and ...could not hear target...interesting...I switched stabiliser on new 4500 from 9 to 1 and was more stable and could even hear target better..tried it on the 5000 and lost the target signal...?...put a 8x6 Satie on thinking it would scream and I could,nt hear it ...had to pull the target up 3 inches before could hear it..? Hope you can understand all that..put the 11inch mono on and couldn't hear it... Coiltek rules.. [/QUOTE]
Verification
Post reply
Metal Detectors
Minelab
Minelab GPX4500 tips, settings, questions
Top