Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Minelab
Minelab Equinox tips and questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="user 14190" data-source="post: 501367" data-attributes="member: 14190"><p>mbasco, I have some of the mono and stereo 3.5 plugs, put one in the lathe and turned it down a bit as the outer plastic was too big to fit in the threaded section of the Equinox, but then found that the base of the pin where it is moulded into the plastic was also too big to fit inside past another section in the socket of the Equinox, so decided to just but the adapter lead. Another reason for trying all this was that the original headphones supplied with the Equinox 600 are only 2 wires, not very thick nor long and no outer shield and I felt that they would not last. I did do a loop that was cable tied to the shaft to take the pressure off the 3.5mm plug, but that made the cable shorter again. Will now use the redundant set from the GPX with the curly and the adapter lead and that should over come all the issues. Thanks for your help.</p><p></p><p>Graham</p></blockquote><p></p>
[QUOTE="user 14190, post: 501367, member: 14190"] mbasco, I have some of the mono and stereo 3.5 plugs, put one in the lathe and turned it down a bit as the outer plastic was too big to fit in the threaded section of the Equinox, but then found that the base of the pin where it is moulded into the plastic was also too big to fit inside past another section in the socket of the Equinox, so decided to just but the adapter lead. Another reason for trying all this was that the original headphones supplied with the Equinox 600 are only 2 wires, not very thick nor long and no outer shield and I felt that they would not last. I did do a loop that was cable tied to the shaft to take the pressure off the 3.5mm plug, but that made the cable shorter again. Will now use the redundant set from the GPX with the curly and the adapter lead and that should over come all the issues. Thanks for your help. Graham [/QUOTE]
Verification
Post reply
Metal Detectors
Minelab
Minelab Equinox tips and questions
Top