Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Minelab
Minelab CTX3030 tips, settings, questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="trev111" data-source="post: 104955" data-attributes="member: 3611"><p>Has any one any idea or info on the following. Yesterday I detected an area and found that the CTX was picking up plenty of interference and whatever I adjusted, the interference continued. When I located a target, I put the detector onto the ground and without moving it it chattered non stop. To locate the target with the pinpointer, I had to turn the machine off. When I raised the detector into the air, it still continued the chattering. I was using it with the Wireless headphones. It continuously picked up ???? signals</p><p>I changed the wireless channel , tried different modes and sensitivity but nothing helped. I went to another area and all was well and the detector worked perfectly</p><p>There were no obvious power lines around but there was a very tall radio tower but it would have been around 300 meters away.. Could that have been the answer??</p><p></p><p>Trev111</p></blockquote><p></p>
[QUOTE="trev111, post: 104955, member: 3611"] Has any one any idea or info on the following. Yesterday I detected an area and found that the CTX was picking up plenty of interference and whatever I adjusted, the interference continued. When I located a target, I put the detector onto the ground and without moving it it chattered non stop. To locate the target with the pinpointer, I had to turn the machine off. When I raised the detector into the air, it still continued the chattering. I was using it with the Wireless headphones. It continuously picked up ???? signals I changed the wireless channel , tried different modes and sensitivity but nothing helped. I went to another area and all was well and the detector worked perfectly There were no obvious power lines around but there was a very tall radio tower but it would have been around 300 meters away.. Could that have been the answer?? Trev111 [/QUOTE]
Verification
Post reply
Metal Detectors
Minelab
Minelab CTX3030 tips, settings, questions
Top