Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
Impact Mill Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Rickrofe" data-source="post: 110470" data-attributes="member: 3596"><p>The feed chute will be placed on the top half of the mill, and will be positioned so that feed enters the mill on the downwards stroke of the spin cycle. I am using 5 mm thick tubing which will be attached at a 90 degree angle to the mill body but bends out at 45 degrees about half way up. This design will help avoid any material being kicked back out the feeder chute. The chute will be about 75 mm wide but will be choked to restrict feed size to no greater than 50 mm.</p></blockquote><p></p>
[QUOTE="Rickrofe, post: 110470, member: 3596"] The feed chute will be placed on the top half of the mill, and will be positioned so that feed enters the mill on the downwards stroke of the spin cycle. I am using 5 mm thick tubing which will be attached at a 90 degree angle to the mill body but bends out at 45 degrees about half way up. This design will help avoid any material being kicked back out the feeder chute. The chute will be about 75 mm wide but will be choked to restrict feed size to no greater than 50 mm. [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
Impact Mill Build
Top