Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
(DIY) F1A4 Simple Mod information (hope it helps)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bmzgold" data-source="post: 104370" data-attributes="member: 3406"><p>Hi Auman</p><p>Ive recently purchased a f1a4 myself and am in the process of modding.</p><p>just wondering if you have any suggestions for the shielded wire, and should it be single stand or double,</p><p>also for anyone that wants to get rid of that heavy lower shaft i have found that a 24mm carbon fiber tube will fit in the upper shaft quite nicely, you just have to swap the the pads in the clamps that hold the arm rest and the lower shaft, i made a fitting to attach the coil from a 20mm 45degree high pressure fitting just heated and flattened one side and drilled a bolt hole, and routed out the other so it would fit on the shaft, when i get time i will have to put up some photos.</p><p>kind regards</p><p>boyd</p></blockquote><p></p>
[QUOTE="bmzgold, post: 104370, member: 3406"] Hi Auman Ive recently purchased a f1a4 myself and am in the process of modding. just wondering if you have any suggestions for the shielded wire, and should it be single stand or double, also for anyone that wants to get rid of that heavy lower shaft i have found that a 24mm carbon fiber tube will fit in the upper shaft quite nicely, you just have to swap the the pads in the clamps that hold the arm rest and the lower shaft, i made a fitting to attach the coil from a 20mm 45degree high pressure fitting just heated and flattened one side and drilled a bolt hole, and routed out the other so it would fit on the shaft, when i get time i will have to put up some photos. kind regards boyd [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
(DIY) F1A4 Simple Mod information (hope it helps)
Top