Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Metal Detecting for Gold
Detecting old aluvial workings
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="KarlS" data-source="post: 86196" data-attributes="member: 2409"><p>My question is there a point in doing it? Is there any chance to find nugget in quite small aluvial area that has been worked over many times. My two recent prospecting trips were to small creek around Oberon. Aluvial gold has been mined there from about 1860 it was fairly rich deposit. Gold comes from old wash that has been covered by volcanic lava and present creek cut thru basalt cover and redistribute old wash along its banks. Detecting close to the creek is hopeless as you get signal every foot or so. Amount of mosty modern junk there is almost as bad as in the parks around place where I live. Bit higher up along the banks the soil is only few inches deep on bedrock. There I found about dozen .22 bullets, few .22 long cartiges and bits of old rusty iron. </p><p>Few test pans produced 1 to 4 flakes of gold, mostly flat and litte bit of flour gold. There is very little of black sand. The wash is mostly small flakes of shale, large water worn black basalt, serpentine rock and some quartz. Am I wasting time trying to find nugget in such a place?</p><p>Karl</p></blockquote><p></p>
[QUOTE="KarlS, post: 86196, member: 2409"] My question is there a point in doing it? Is there any chance to find nugget in quite small aluvial area that has been worked over many times. My two recent prospecting trips were to small creek around Oberon. Aluvial gold has been mined there from about 1860 it was fairly rich deposit. Gold comes from old wash that has been covered by volcanic lava and present creek cut thru basalt cover and redistribute old wash along its banks. Detecting close to the creek is hopeless as you get signal every foot or so. Amount of mosty modern junk there is almost as bad as in the parks around place where I live. Bit higher up along the banks the soil is only few inches deep on bedrock. There I found about dozen .22 bullets, few .22 long cartiges and bits of old rusty iron. Few test pans produced 1 to 4 flakes of gold, mostly flat and litte bit of flour gold. There is very little of black sand. The wash is mostly small flakes of shale, large water worn black basalt, serpentine rock and some quartz. Am I wasting time trying to find nugget in such a place? Karl [/QUOTE]
Verification
Post reply
Gold Prospecting
Metal Detecting for Gold
Detecting old aluvial workings
Top