Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
General
General Chat
Cutting Steel Rings from an 8.5kg gas cylinder
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Dihusky" data-source="post: 572670" data-attributes="member: 10304"><p>5-6mm, fairly narrow bands, I'd be setting up a pair of rollers with a bar to steady your hand. Cut with a 125 x 1.2mm cutting disc, the type used for cutting stainless, bit of care and should do the job fine, just don't push the blade, allow it to cut at the rate it wants to cut.</p></blockquote><p></p>
[QUOTE="Dihusky, post: 572670, member: 10304"] 5-6mm, fairly narrow bands, I'd be setting up a pair of rollers with a bar to steady your hand. Cut with a 125 x 1.2mm cutting disc, the type used for cutting stainless, bit of care and should do the job fine, just don't push the blade, allow it to cut at the rate it wants to cut. [/QUOTE]
Verification
Post reply
General
General Chat
Cutting Steel Rings from an 8.5kg gas cylinder
Top