Amazon/EBay Faceting Machines

[joe]

After searching for a second hand faceting machine for a while without success I’ve decided to take on a challenge and get one of those cheap one’s knowing there will be some modifications required. - in progress

(1) mast base off centre( 2.5mm) required machining.

(2) master lap run out of about 0.8mm required machining

(3) arbor adaptor required in order cut girdle (manufactured/machined)

(4) replacement of cheap thumb screws and nuts

Total extra cost of $185.00

I’m now able to get consistent angles with the supplied digi reader. Just wanted to share my experience so far. I’m not at the cutting stage yet,

 

[joe]

Motor variable speed controller function (reverse and forward)
View attachment IMG_5631.MOV

 

[joe]

In reverse (I’m guessing if you want the water splashing away from you)
View attachment IMG_5637.MOV

 

[joe]

Added washer to restrict the arm moving sideways
View attachment IMG_5638.MOV

 

[joe]

Added spacer if you need the quill to move freely
View attachment IMG_5639.MOV

 

[joe]

Added couple of thumb nuts for the angle hard stop and fine adjustment as well as bicycle quick release instead of nut and bolt.