Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gemstones, Minerals & Fossils
Lapidary
Actually Building the Machine!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Nena" data-source="post: 359081" data-attributes="member: 7861"><p>What do you think your overal accuracy will be?! And why arent you using block guides?! Hope it is all working out for you. I have seen many machines but the accuracy is very poor at the end. Mayby you should redesign your setup. As it looks to me you will get some troubles with holding the head. Your design is for small stones but i wonder if its going to work for fully fecet the stone. How about 90degrees?! And is it possible to cut stones under de 1mm? The goal with my machine is cutting stones under the one milimeter up to 120mm in diameter. (max 2.2kg stones) and the complete setup will be smaller then 1/100 of a mm. Till now im about 0.008mm for the complete machine. Linear rods going to set stuck in a few times with cutting stones. I dont think thats a good solution to use.</p></blockquote><p></p>
[QUOTE="Nena, post: 359081, member: 7861"] What do you think your overal accuracy will be?! And why arent you using block guides?! Hope it is all working out for you. I have seen many machines but the accuracy is very poor at the end. Mayby you should redesign your setup. As it looks to me you will get some troubles with holding the head. Your design is for small stones but i wonder if its going to work for fully fecet the stone. How about 90degrees?! And is it possible to cut stones under de 1mm? The goal with my machine is cutting stones under the one milimeter up to 120mm in diameter. (max 2.2kg stones) and the complete setup will be smaller then 1/100 of a mm. Till now im about 0.008mm for the complete machine. Linear rods going to set stuck in a few times with cutting stones. I dont think thats a good solution to use. [/QUOTE]
Verification
Post reply
Gemstones, Minerals & Fossils
Lapidary
Actually Building the Machine!
Top