Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gemstones, Minerals & Fossils
Lapidary
⭐ Show Us Your Cut Stones - Before And After Photos
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Wally69" data-source="post: 529332" data-attributes="member: 1916"><p>Doped straight on the top of the X with superglue - was slightly off centre but dont think that matters, other than making the corners a bit off the filament plane. </p><p></p><p>Had plenty of depth in the stone, so trimmed a couple of mm off with a saw when I transferred it, so if dropping on the adjacent side, the x might end up low or high and might give a more dominant colour spectrum. - worth an experiment</p></blockquote><p></p>
[QUOTE="Wally69, post: 529332, member: 1916"] Doped straight on the top of the X with superglue - was slightly off centre but dont think that matters, other than making the corners a bit off the filament plane. Had plenty of depth in the stone, so trimmed a couple of mm off with a saw when I transferred it, so if dropping on the adjacent side, the x might end up low or high and might give a more dominant colour spectrum. - worth an experiment [/QUOTE]
Verification
Post reply
Gemstones, Minerals & Fossils
Lapidary
⭐ Show Us Your Cut Stones - Before And After Photos
Top