Recent content by oldjoe

Is the dxf file still available for the mini bazooka sluice shown here, I used to have the file but multiple crashes and drive failures mean it's long gone I have the pdf. I need the dxf to run through a cnc router table.

I own 2 of them, they are very fast and hold gold very well there only draw back that I found was they require deeper water to bring the pan to almost vertical to process the pan, not so much to classify but to clean all the over burden. Way faster than any round pan about 4 times faster or my...

Thanks I found your measurements but not the pictures metric is not my strong suite, the croc was only 18 inches overall or 460mm, 660mm would be 26 inch, I'm looking for croc measurements as small works better in my back pack on my old Beemer

Post one here living on the west coast of Canada shipping for a croc if it were available is out of the question so to anyone that has one I require a few simple dimensions. 1 length is 18 inches got that one. 2 top width -? 3 bottom width -? 4 height from bottom to top of side walls -? 5...