Recent content by Muzza

If one is genuinely interested then I guess they would follow up and ask!

OK. It seems I have come under a bit of critism for my post! Sorry, to anyone offended, this is my first post and not a long time member so try to be a bit tollerant with me. As there are multiple questions asked I shall cover them all in one reply post. WHAT IS THE CAPACITY PER HOUR. A. The...

OK. It seems I have come under a bit of critism for my post! Sorry, to anyone offended, this is my first post and not a long time member so try to be a bit tollerant with me. As there are multiple questions asked I shall cover them all in one reply post. WHERE AM I? Perth WA. WHAT IS THE...

Brand new jaw crusher for sale. Feed chute 120mm x 110mm Jaw adjustment anywhere from 6mm up to 42mm. Ideal as primary crusher before ball or hammer mill. Or crushing down for tumbling. I bought two crushers, one for myself and one for a neighbor at a nearby small Hard rock mine and he has...

Slabman. Ok thanks, to dress a diamond blade is it the same method as dressing a grinding wheel? ie a light touch on each side ond a pass over the top edge?

No. It is a mineral oil with a lot of use in the cosmetics industry but is a very fine oil similar to sewing machine oil.

Dihusky. Lubricant is Isopro l, have been using it for quite some time and havent noticed any problems with it?

Yes good point, will try that today.

SC. Thanks for comment, at least i now know i'm not alone. I am doing both, thin blade and deep cut. Perhaps i should change the driven pulley for a larger Dia to slow the feed even more, it is on slowest now according to pulleys fitted.

MH. Pretty much all cuts. I have noticed since posting this, that if i let the cut start and cut a little say 1/2 inch into the rock, then stop the blade, withdraw it from the cut and gently push the saw table back in to re-engage the blade back in the cut, then the cut is allready out by the...

I have a Gemmaster slabbing saw with 10" diamond blade. It has two white nylon pads below the cutting table, which i presume should be adjusted to touch the blade with gentle pressure. Auto feed table which is set to slowest feed using existing pulley combinations. Problem is that it is not...

Ok. Thanks, that is some food for thought, I reckon sides on a tyre would be necessary else over time all your lapping/grinding medium would eventually splash out. Easy to put sides on i think only need one side fixed and the other opening somehow?

Gilly. 47 Do they seal the sides in any way? If so do you know what they have done?

Mangoat. I am far from experienced with Garnet, but a recent trip to the Gemfields in NT saw us using the smaller size sieves as mentioned in others posts here, yhen when all the loose dirt had been sieved out we washed the remaining gravel in a large pot capable of taking the full diameter of...

Thanks Muk. I had not thought of making a barrel from various pieces. I did look a doing it all from polly plumbing bits but this worked out surprisingly expensive. I am restricted by this site as to what i can do by way of reply to you, i will see if i can contact you privately for a chat, but...