You are not logged in.

  • Register to access all forum features  


Joined: 19 August 2019
Posts: 8
09 September 2019 09:56 pm

Hi all, I've found a 12V charger to suit the Lithium Polymer cells of the QED PL2.

This is a low cost unit that I have tested successfully with my PL2 unit. I know Howard is also testing this unit as well. It's not an official QED accessory, and will require the charging cable supplied with your PL2 to work.

The unit accepts a DC 5.5/2.1mm plug.

A cigarette lighter socket adaptor isn't included and will need to purchased separately if this how you want to connect it. Please read the safety notice in the instructions, and as always when charging lithium polymer cells you do so at your own risk.

Manual, with safety notice. … 677X58.pdf

12V 2S-3S Balance charger … tore=en_us

Short cable (length unknown) … rgers.html

Longer cable (1.5m) Jaycar part# PP2008 … g/p/PP2008

Even longer cable (2.5m) … .1mm-plug/


Qed Pl2

2 users like this post: Ded Driver, Aussiedigs


Ded Driver
From: West of the Border, WA
Joined: 27 May 2018
Posts: 2,385
09 September 2019 10:17 pm

hopefully that goes well, but at $5.10 ($US I assume) I would be a bit concerned about either the safety when charging, &/or the life of the unit.
It would be a good idea to keep an eye on it & check/feel for overheating or any issues, both in the batteries & the unit.

APLA member, GPX4000, modded SD2100, XTerra705, GM1000, Whites MXT Pro, Nokta Pointer, sP01 Enhancer, Garmin GPSMAP 64S, kti PLB, a map, all sorts of coils & a cupla buckets full of hope & enthusiasm

Contact Us - Privacy Policy - Terms Of Service

View Desktop Site