do you have any way of getting accurate measurements off those dies , or do you want to sell that gear and if so how much dollars would want.7.62marksman said:Have them as well mate if that helps
they make em to fit most lathes mate . though hard to find for some lathes i was lucky and got onto 2 of them one for me and one for a mates lathe. course you can cut short tapers just using your compound slide . most lathes are built so that the compound travel is long enough to cut a morse taper to suit the taper of that machine . so for instance if your machine has a number 3 morse taper spindle your compound should have enough travel to make its own tooling .i made a few morse blanks and a collet chuck for my lathe before i got this taper attachment .caparobertsan said:WOW I like that taper attachment! Yes it is very hard to control 2 handle same time to make taper! Very very good!
I want one!
Enter your email address to join: