Hi all
I seperated the wires from the proprietry connection on my koss headphones (SDC 2300)
Yes I am going to upgrade headphones.
I still want to try to fix the broken ones for a spare set.
Does anyone know the connections in relation to where black red and white should be soldered into the connector.
I tried
black to 5 and 6 pins
white to 2 pin
red to 3 pin
I think these are the right pins as they were the only ones with solder on them.
The phones worked (sort of) with this, however there was a continuous noise besides the usual warble.
It did make the usual noises when i tried the detector on lead and gold.
I am wondering if the continual noise is perhaps i over soldered and have inadvertantly hit another pin.
I can't see this but wondering?
Any advice appreciated
(This is the connector at the end of the headphone lead that plugs into the sdc)
Neil
I seperated the wires from the proprietry connection on my koss headphones (SDC 2300)
Yes I am going to upgrade headphones.
I still want to try to fix the broken ones for a spare set.
Does anyone know the connections in relation to where black red and white should be soldered into the connector.
I tried
black to 5 and 6 pins
white to 2 pin
red to 3 pin
I think these are the right pins as they were the only ones with solder on them.
The phones worked (sort of) with this, however there was a continuous noise besides the usual warble.
It did make the usual noises when i tried the detector on lead and gold.
I am wondering if the continual noise is perhaps i over soldered and have inadvertantly hit another pin.
I can't see this but wondering?
Any advice appreciated
(This is the connector at the end of the headphone lead that plugs into the sdc)
Neil