Chain mill advice needed please.

Prospecting Australia

Help Support Prospecting Australia:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

AussieMate

Arnie Kroezen
Joined
Aug 6, 2019
Messages
10
Reaction score
94
Location
Darwin, NT
Hi guys.

I'm in the process of building a chain mill (tight budget) to fine crush quartz rock for gold. The drum will be hexagon shaped, 150mm wide and an inside diameter of 320mm. It will be driven by a 4stroke 6.5hp petrol motor with pulleys and belt. The chains inside will have hard-faced paddles on the ends.

My question is, what would be a good rpm to aim for?

Cheers
 
i think you need to target around 3.5k , a lot of these engines don't have throttle controll and simply use a governor to controll butterfly based on load... IE pressure washers and generators...
 
If you look at the power curve for small stationary engines , you will see that the greater power out put is when it is going faster . But it is using more fuel ! You will get more power out put at 3,000 r.p.m than 1,500 r.p.m. If it is governor controlled , you can make it adjustable with a bit of fencing wire ....
 
I made one with a single cyl diesel....I just control the rpm's with the throttle. What I find is the size of material feed and quantity
and most importantly moisture content is what bogs down the crusher. I always run the thing near flat out and it works fine!
 
If you are using a 6.5 h.p. engine , I suggest you use twin vee belts .
 
Just disconnect the govener so the engine doesnt bog down I do this to all my small engines and it works a treat
 

Latest posts

Top