- Joined
- Oct 23, 2019
- Messages
- 134
- Reaction score
- 196
Unclear areas in Settings for the ORX in Gold mode.
The reason I ask all these questions is I just completed a trip using the ORX where hot rocks\Mineralised ground made detecting any targets impossible. I followed Clegys instructions and tried many different settings but to no avail. What did work is Clegys advice to hit the Pubs. One of the biggest problems was the elliptical coil was so bump touchy. I could not get the coil anywhere near the ground when keeping the GB numbers the same.
I have Quoted the Manual and Clegys settings I mention are from: Clegys XP ORX Settings for Gold in Australia when the going gets a little tough in mineralised areas Link Below:
https://aussiedetectorist.com.au/20...few-minor-tweaks-for-some-major-improvements/
Disc IAR. In the manual it talks about a lot, but explains nothing to do with Gold Mode.
Is Disc IAR not of any use to reduce Hot rock\Mineraliseation Noise; or can a setting of 1 or 2 help to reduce noise ? With coin modes it relates to TID numbers. What about in Gold mode is Disc IAR doing the same thing?
Manual states : It Applies only to targets that produce strong signals typically shallow ferrous items. IAR will not reject deeper targets which may come across as ferrous when they are buried in mineralised ground, this is to ensure good targets are not rejected by mistake. Gold nuggets (buried deep in mineralised ground) generate a similar target signature to a ferrous item. So in this case, it is better to reduce the level of discrimination. Clegy makes no mention of DISC IAR use in mineralised ground.
Iron Volume : Activate / de-activate the low ferrous tone. So If I turn Iron Volume Off in Gold Mode I should only hear target noise not Iron\Ferrous targets
The reason I ask all these questions is I just completed a trip using the ORX where hot rocks\Mineralised ground made detecting any targets impossible. I followed Clegys instructions and tried many different settings but to no avail. What did work is Clegys advice to hit the Pubs. One of the biggest problems was the elliptical coil was so bump touchy. I could not get the coil anywhere near the ground when keeping the GB numbers the same.
I have Quoted the Manual and Clegys settings I mention are from: Clegys XP ORX Settings for Gold in Australia when the going gets a little tough in mineralised areas Link Below:
https://aussiedetectorist.com.au/20...few-minor-tweaks-for-some-major-improvements/
Disc IAR. In the manual it talks about a lot, but explains nothing to do with Gold Mode.
Is Disc IAR not of any use to reduce Hot rock\Mineraliseation Noise; or can a setting of 1 or 2 help to reduce noise ? With coin modes it relates to TID numbers. What about in Gold mode is Disc IAR doing the same thing?
Manual states : It Applies only to targets that produce strong signals typically shallow ferrous items. IAR will not reject deeper targets which may come across as ferrous when they are buried in mineralised ground, this is to ensure good targets are not rejected by mistake. Gold nuggets (buried deep in mineralised ground) generate a similar target signature to a ferrous item. So in this case, it is better to reduce the level of discrimination. Clegy makes no mention of DISC IAR use in mineralised ground.
Iron Volume : Activate / de-activate the low ferrous tone. So If I turn Iron Volume Off in Gold Mode I should only hear target noise not Iron\Ferrous targets